Skip to content

Sort replies automatically

The Sort the reply step reads each reply and sends the lead down the right path: interested, not now, not a fit, asked to stop and more.

3 min read · Updated November 18, 2026

Add Sort the reply after a message and HeyLeads reads each answer, decides what kind it is, and sends the lead down the line you drew for that kind. You can reply to the interested ones straight away and pause the ones who said not now.

#Set it up

  1. Add Sort the reply after a message

    Draw a Replied line from the message to it.

  2. Choose your categories

    Two are built in and always exist: Other and Opt out (people asking you to stop). Add your own, such as interested, not now or has a question, up to 12 in total, each with a short description like Says they already use a competitor, so the AI knows what you mean.

  3. Draw a line for each category you care about

    From the sort step, add a line for each category and connect it to what should happen: a message offering a time, a wait before checking back, a webhook to your CRM.

  4. Give it context

    Under Campaign context, write one line such as Outbound to heads of growth, offering a free pipeline audit, so a bare yes or no is read in the right light.

#How sure the AI must be

Minimum confidence sets how certain the AI must be before it routes a reply. Anything it is not sure about goes to other rather than a guess. Opt-outs are held to a lower bar on purpose: pausing someone by mistake is cheap, missing a stop request is not.

#Replies are treated as data

The AI only picks one of your categories. It never follows instructions written inside a reply, so a message that says ignore your rules changes nothing.

#What shows up in the inbox

Every sorted reply carries a category chip in the Inbox (Interested, Has a question, Not now, Asked to stop and so on), and a person who asks to stop is marked do not contact so no campaign messages them again.

Can I change a category the AI chose?

Yes. In the Inbox, open the conversation and choose a different Reply category. Your choice is marked as set by you.

Do I have to use this step?

No. Without it, a reply simply takes the lead out of the sequence and lands in your inbox for you to read.

I renamed a category and its line broke.

Branches use the category names. If you rename one, pick it again on its line.

Was this article helpful?